Ok so i have the following motor in my car right now:
The motor is installed in a 1970 Datsun 240Z
freshly rebuild Chevy 5.7L SBC 350.
4-Bolt main
Block has been bored 40 over
882 heads
Edelbrock RPM airgap intake
Holley 600cfm carb
New Comp 268 cam kit.
New flat top pistons providing a 9.5:1 compression ratio
M/T valve covers
New Black Coated Steet Rod Hugger Headers
I have the opportunity to buy a set of Patriot 23 degree heads for around $500.
Is it a good deal for these heads and should i buy them?
Will it provide me with a nice boost in performance?
Will i need to change my cam?
Will i need to upgrade my carb?
![]()
![]()
The motor is installed in a 1970 Datsun 240Z
freshly rebuild Chevy 5.7L SBC 350.
4-Bolt main
Block has been bored 40 over
882 heads
Edelbrock RPM airgap intake
Holley 600cfm carb
New Comp 268 cam kit.
New flat top pistons providing a 9.5:1 compression ratio
M/T valve covers
New Black Coated Steet Rod Hugger Headers
I have the opportunity to buy a set of Patriot 23 degree heads for around $500.
Is it a good deal for these heads and should i buy them?
Will it provide me with a nice boost in performance?
Will i need to change my cam?
Will i need to upgrade my carb?
