I am in process of doing a frame up rebuild on a '92 Jeep Wrangler with a conversion to install a 400 SBC that has been/is in process of being built out.
The Jeep conversion place I have been getting parts/advice from recommends block hugger headers with a Y pipe into a single exhaust. Of course the headers they sell are pricy.
There are a lot of SBC header options even within the block hugger variety so I was wondering is anyone here has advice about using block huggers with a Y pipe verses wide headers to go outside the frame. I presume if I go outside the frame I would run dual out the back.
Any recommendations on header sources also appreciated.
The Jeep conversion place I have been getting parts/advice from recommends block hugger headers with a Y pipe into a single exhaust. Of course the headers they sell are pricy.
There are a lot of SBC header options even within the block hugger variety so I was wondering is anyone here has advice about using block huggers with a Y pipe verses wide headers to go outside the frame. I presume if I go outside the frame I would run dual out the back.
Any recommendations on header sources also appreciated.