Well I have a 2 bolt main 350. This is a BUDGET build. Im planning on keeping it standard bore with 4 valve relief flat tops, either a set of 291 double humps or a set of 462's both have screw in studs and guide plates ($100 each set, cant pass that up), summit 218/218 450/450 106lsa flat tappet cam, Summit valve springs, edelbrock performer intake, edelbrock 600 carb, 1 1/2 long tube headers, 26 degree timing advanced hei dizzy, new main and rod bearings, stock rods. What can I expect out of this motor? Is this cam good? I want some thump but I want to keep my factory converter. I heard that summit cams are old crane grinds, which would be okay for my factory heads right? I was hoping to break 300hp with this motor but would really like to have some preferences from some of you guys.
↧